[Top] [All Lists]

Re: Topband: Detuning Relay Flyback Diode

To: <>
Subject: Re: Topband: Detuning Relay Flyback Diode
From: "Paul Christensen" <>
Date: Sat, 23 Dec 2017 11:15:45 -0500
List-post: <>

If you use an LED with a dropping resistor across the coil to monitor relay
status, then you must use a fly-back diode.  The coil of the type you're
using will produce substantial EMF as power is removed and the coil field
rapidly collapses.  The collapsing field will produce E-I beyond the LED's
maximum ratings.  Failure occurs even when the LED is current-limited
through a series dropping resistor.   

On my remote-controlled homebrew balanced tuner, I was replacing LEDs until
I discovered that the collapsing vacuum relay field was immediately burning
out LEDs.  Never a problem after installing 1N400X fly-back diodes.

Paul, W9AC

-----Original Message-----
From: Topband [] On Behalf Of Brad
Sent: Saturday, December 23, 2017 10:52 AM
Subject: Topband: Detuning Relay Flyback Diode

I have a couple of 6ms 12V Kilovac relays wired up as a detuning circuit
during RX.  One question comes up before implementation regarding flyback
diodes - would they be needed?  Seeking opinions on this question.  The
relays are powered during TX and not powered for RX direct keyed by the
radio with no sequencer.


Brad W1NT <>
Topband Reflector Archives -

Topband Reflector Archives -

<Prev in Thread] Current Thread [Next in Thread>