Also, when you want to remove them the steel center pins tend to make the
drill bit walk and you end up with an egg shaped hole.
Bill, KB3AUG
Riverton,WV
On Tue, 25 Mar 1997 17:44:06 -0500 [email protected] writes:
>Just make sure you use pop rivets with an aluminum center pin. The
>steel
>center pins will corrode out in a hurry when outsdie in the weather...
>
>
>Stan, WA1ECF Cape Cod, MA
>
>
>
>--
>FAQ on WWW: http://www.contesting.com/towertalkfaq.html
>Submissions: [email protected]
>Administrative requests: [email protected]
>Problems: [email protected]
>Sponsored by: Akorn Access, Inc. & N4VJ / K4AAA
>
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: [email protected]
Administrative requests: [email protected]
Problems: [email protected]
Sponsored by: Akorn Access, Inc. & N4VJ / K4AAA
|