Towertalk
[Top] [All Lists]

[TowerTalk] Mast section modulus correction

To: <towertalk@contesting.com>
Subject: [TowerTalk] Mast section modulus correction
From: psoper@donedeal.encore.com (Pete Soper)
Date: Thu, 01 May 1997 09:52:54 -0400
(Toss that last "cookbook" message I sent into the bit bucket. Stan 
Griffiths was kind enough to point out that I botched the formula
description. Here is what I should have written)

For the folks that enjoy knowing how to do this stuff yourselves:
 
Section modulus(of a hollow cylinder) = pi*(D**4 - d**4)/32D

Where D is the outer diameter and d is D minus two times the wall thickness,
"*" means multiply and "**" means raise to the power of (and pi is 3.1415).

If you divide the section modulus into the inch-pounds of force on the mast
you get the bending stress which must be less than the yield strength of the
material to avoid damage.

(From pages 3-4 to 3-6 of the Leeson book)

Regards,
Pete
KS4XG

--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com

<Prev in Thread] Current Thread [Next in Thread>
  • [TowerTalk] Mast section modulus correction, Pete Soper <=