Towertalk
[Top] [All Lists]

[TowerTalk] Separating Aluminum Tower Sections

To: <towertalk@contesting.com>
Subject: [TowerTalk] Separating Aluminum Tower Sections
From: wd4ngb@sprynet.com (Bruce Richards)
Date: Sun, 28 Sep 1997 21:25:31 +0100
Jeff Maass wrote

> I've been offered five 8-foot sections of aluminum tower, but the owner
> has been unable to get them apart.
>
> Any tips? Any techniques (chemical or mechanical) to loosen seized pieces? I
> was considering jacks, but with aluminum I'm concerned about bending.
>
> 73,
>
> Jeff Maass       
>
You may wish to try it like I did once. A guy was going to sell a tower
he had 40ft laying dowm connected to a 25G hinge. He couldnt get the
sections apart. I tried helping him, and with out the correct tools, we
didnt have much luck. He got mad and told me if I could get rid of it I
could have it. I went and got motorcycle trailer and loaded one end of
tower on trailer and chained the other end to trailer hitch. I waited
ontill early morning when no traffic and drove it home like a long
trailer. 73/DX........Bruce

-------------------------------------------------------------------
                    "Where Bigger Is Better"
DX Page: 
http://home.sprynet.com/sprynet/wd4ngb
E-Mail:          wd4ngb@sprynet.com
Clarksville Tn. (50 miles NW of Nashville Tn)

--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com
Search:                   http://www.contesting.com/km9p/search

<Prev in Thread] Current Thread [Next in Thread>