Towertalk
[Top] [All Lists]

[TowerTalk] "Pre-install" Your Rotator

To: <towertalk@contesting.com>
Subject: [TowerTalk] "Pre-install" Your Rotator
From: K7LXC@aol.com (K7LXC@aol.com)
Date: Sat, 1 Nov 1997 18:07:29 -0500 (EST)
In a message dated 97-10-31 11:39:33 EST, DavidHarper@tx.slr.com writes:

<< >       While you're testing rotators on the ground, I prefer to have
 > them set
 > to North as the final step. It simplifies the beam alignment when
 > you're
 > finishing the installation.
 > 
 At my previous QTH, there were no obvious landmarks for North
 (treetops), so I always set the rotor to 30-degrees because I knew that
 was the heading where a good sighting landmark did exist (aimed straight
 down my roof-line). >>

      Okay. Or any other known landmark/heading. In most communities, some of
the streets are laid out north-south and east-west.

73,  Steve  K7LXC

73,  Steve  K7LXC

--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com
Search:                   http://www.contesting.com/km9p/search

<Prev in Thread] Current Thread [Next in Thread>