In a message dated 98-02-19 00:18:04 EST, [email protected] writes:
> What did I do wrong? What could I have done to prevent this from
> happening?
Sounds like they were stainless steel and the threads galled during
installation. They're okay until you want to remove them - then they break. In
the future, put a little bit of anti-seize on the threads (that's why they
make it). Even some anti-oxidant from your toolbox will work too.
73, Steve K7LXC
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: [email protected]
Administrative requests: [email protected]
Problems: [email protected]
Search: http://www.contesting.com/km9p/search
|