Towertalk
[Top] [All Lists]

[TowerTalk] refurbish a Thrust bearing ?

To: <towertalk@contesting.com>
Subject: [TowerTalk] refurbish a Thrust bearing ?
From: n7ex@athenet.net (Dave_K9NX)
Date: Sat, 12 Sep 1998 14:29:04 +0000
At 11:39 PM 9/11/98 -0600, T A RUSSELL wrote:
>
>Hi  Bill,
>
>Why use a thrust bearing at all?
>
>Most rotors can carry several hundred pounds of dead weight
>which helps keep their bearings in their races.  If a single
>thrust bearing is used at the top of the tower and it is tightened
>to carry the weight of the mast and antennas, then the side load
>actually increases on the rotor, increasing wear on the races in
>the rotor.  NOT a good plan.

Tom
Hmmmm..........

Explain how you would calculate the side loads on the rotator in both cases
below. 

First case: The weight of the mast supported by the thrust bearing,

Second case: Weight of the mast supported entirely by the rotator, Assume
the mast  has minimal (few thousandths) of play where it  goes through the
top of the tower.


Dave
K9NX

>
>de  Tom  N4KG
>
>
>_____________________________________________________________________
>You don't need to buy Internet access to use free Internet e-mail.
>Get completely free e-mail from Juno at http://www.juno.com
>Or call Juno at (800) 654-JUNO [654-5866]
>
>--
>FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
>Submissions:              towertalk@contesting.com
>Administrative requests:  towertalk-REQUEST@contesting.com
>Problems:                 owner-towertalk@contesting.com
>Search:                   http://www.contesting.com/km9p/search.htm
> 

--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>