From:
Fred Hopengarten K1VR 781/259-0088
Six Willarch Road
Lincoln, MA 01773-5105
permanent e-mail address: fhopengarten@mba1972.hbs.edu
On Tue, 6 Oct 1998 20:07:47 -0400 (EDT) Mike Sims <nasfred@1bigred.com>
writes:
>Do you have a way of getting the aluminum capacitance cap off of the
>trap?
>The traps' aluminum capacitance caps have been peened(?) on either
>side of
>the plastic spacers in the trap.
K1VR: There are two ways and neither of them is delicate nor elegant.
The dimples are the problem.
1. You can just whack on the aluminum shell with a big screwdriver
driven by a hammer and force your way out of the dimple, or
2. You can create, out of wood or metal, something to hold the plastic
in place while you move the aluminum shell, OR create, out of wood or
metal, something to hold the shell inplace while you whack on the
plastic.
There is always a danger that you will break something.
You might ask WB0DGF of HyGain, who reads the TT reflector, if there is a
more elegant way. One way that I've seen described, but never used, is
to drill out the dimple and remove the metal drilled out. Use a very
sharp drill. This may effectively eliminate the dimple and you could
create another one later. All of this is craftsmanship, of which I know
nothing. I have many friends who vouch for that latter statement.
-- Fred K1VR
___________________________________________________________________
You don't need to buy Internet access to use free Internet e-mail.
Get completely free e-mail from Juno at http://www.juno.com
or call Juno at (800) 654-JUNO [654-5866]
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|