On Thu, 15 Oct 1998 07:22:43 -0500, Mikey@a-o.com (Mikey) wrote:
>
>I have a question..Have any of you installed a T2X rotor in a Rohn 25G
>tower, and if so, how did you mount it? I am replacing a Ham IV that is
>giving problems with the T2x, but it is too big to fit inside..Any help
>appreciated..73, Mike W4SMG
_____________________________________________________________
I had the same problem back in '92 and there is a simple solution.
Remove the mounting plate the T2X sits on and re-install it upside
down. That gives you about an inch more clearance to get it in and
that's all you need. Works like a charm. I told the Rohn factory
about that and their response was "we'll look into it". Never heard
back from them. Could be later production towers have it fixed by
now.
73, Bill W7TI
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|