Towertalk
[Top] [All Lists]

[TowerTalk] RE:Questions

To: <towertalk@contesting.com>
Subject: [TowerTalk] RE:Questions
From: K7LXC@aol.com (K7LXC@aol.com)
Date: Fri, 6 Apr 2001 18:07:03 EDT
In a message dated 4/6/01 10:19:05 AM Pacific Daylight Time, 
JClymerjr@aol.com writes:

> For those interested in Gripples, please see: 
>  http://www.gripple.co.uk/indust/index.htm.

    This is a UK idea that Rohn looked at several years ago. I don't remember 
if it'll handle EHS but hams will NEVER use this system because you need to 
buy the terminations and a special tool. 
>  
>  With regard to my question about the "bending moment" of 6061-T6 aluminum, 
>  what I was actually looking for was the approx. yield strength of 2" O.D., 
>  .375 wall, round aluminum tubing.

    6061-T6 has a yield strength of 35,000 psi. The figure is for the 
material so the particular configuration has little to do with it. 

Cheers,    Steve    K7LXC
Tower Tech

List Sponsor:  ChampionRadio.com - Trylon self-supporting towers, safety
equipment, rigging gear, LOOS tension guages & more!  
http://www.championradio.com

-----
FAQ on WWW:               http://www.contesting.com/FAQ/towertalk
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com


<Prev in Thread] Current Thread [Next in Thread>