I have aluminum rectangular blocks (4"x4"x1") that I need to cut a 3"
diameter hole in (using them instead of muffler clamps). I tried a bi-metal
hole saw and also a circle cutter with not much success since I need to make
about blocks altogether. I have a metal lathe that I can bore the finish
diameter on but I would like to get a big chunk of the material out of the
way (to save some time). I have also thought of using a smaller drill bit
(1/2") and drilling a series of holes around the diameter and may do this
but there seems like there has to be a better (less labor intensive) way.
Thanks
Mike W9RE
List Sponsor: Are you thinking about installing a tower this summer? Call us
for information on our fabulous Trylon Titan self-supporting towers - up to
96-feet for less than $2000! at 888-833-3104 <A
HREF="http://www.ChampionRadio.com";>
www.ChampionRadio.com</A>
-----
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
|