Towertalk
[Top] [All Lists]

[TowerTalk] Re: Tower Talk Digest V4 #442

To: <towertalk@contesting.com>
Subject: [TowerTalk] Re: Tower Talk Digest V4 #442
From: w7ni@easystreet.com (Stan or Patricia Griffiths)
Date: Wed, 03 Oct 2001 14:45:55 -0700
Having seen the Rohn torque bars for 25, 45, and 55, I can tell you they are
different for each tower model, with 55G using significanly larger torque arms
than 25G.  I know of no source for these bars at this time.

Stan
w7ni@easystreet.com

teamw wrote:

> Hi Mike
> I do not have any TB55D torque arms but I do have five new and unused TB25D
> bars. These are of course heavily hot dip galv. and would be an improvement
> over home brew unless you can get them hot dipped. Here in Florida anything
> else would rust in no time. I suspect the torque bar may be a common part
> used on the 25, 45 and 55 towers with different sleeves to accomodate the
> different bolts??
> The TBXXD part number describes the torque bar plus the appropriate sleeve.
>
> The TB25D is 16 inches from the outer end to the middle of the hole in the
> loop. I don't see why they would make them longer for either the 45 or 55
> tower? the stock material is 1/4 inch thick and 1-1/4 inches wide. They are
> marked with the P/N, KC796
> The loop inside diameter is 1-1/4 inches. A tubular sleeve goes in the loop
> to accomodate the 1/2 inch bolt used on the 25 tower.
> The 55 tower uses a 3/4 inch bolt requiring a different sleeve.
>
> My Rohn drawing for the Guy bracket assy covers all three towers but gives
> no info at all on the torque bars.
> Both the Commercial and Consumer catalogs show a sketch of the Guy Brackets
> and Torque Bars in the Model 25 sections but there is nothing for either in
> the 45 and 55 section?
> If my assumption is correct about common part for the torque bar and they
> are of interest to you they are available for $12 each plus shipping at
> cost. No charge for packing. Maybe Rohn would confirm whether the KC796 was
> the same bar used on all three?
> regards
> John AB4ET
>
> List Sponsored by AN Wireless:  AN Wireless handles Rohn tower systems,
> Trylon Titan towers, coax, hardline and more. Also check out our self
> supporting towers up to 100 feet for under $1500!!  http://www.anwireless.com
>
> -----
> FAQ on WWW:               http://www.contesting.com/FAQ/towertalk
> Submissions:              towertalk@contesting.com
> Administrative requests:  towertalk-REQUEST@contesting.com
> Problems:                 owner-towertalk@contesting.com




List Sponsored by AN Wireless:  AN Wireless handles Rohn tower systems,
Trylon Titan towers, coax, hardline and more. Also check out our self
supporting towers up to 100 feet for under $1500!!  http://www.anwireless.com

-----
FAQ on WWW:               http://www.contesting.com/FAQ/towertalk
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com


<Prev in Thread] Current Thread [Next in Thread>