Towertalk
[Top] [All Lists]

[TowerTalk] Remove enamel from CU wire

To: <towertalk@contesting.com>
Subject: [TowerTalk] Remove enamel from CU wire
From: jreisert@jlc.net (Joe Reisert)
Date: Mon, 08 Oct 2001 19:37:01 -0400
Sylvan,

I think you are referring to a bottle from General Cement called "strip-X" 
or something like that.

A few years ago I tried to buy some and was told it was a hazardous 
material and was either no long available or had to be shipped as hazardous 
material. I didn't want the responsibility so I went back to using a pen 
knife to strip wires!

73,

Joe, W1JR


At 08:41 AM 10/8/01 -0600, Sylvan Katz wrote:

>I managed to scrounge quite a bit of enamel coated copper wire for my radial
>system from a local motor rewinder.
>In days gone by I could buy small bottles of enamel remover but I do not
>recall what solvent it contained.
>What solvent can I use to remove the enamel?
>
>.. sylvan
>
>----------------
>Sylvan Katz, VE5ZX
>Saskatoon, SK
>
>
>List Sponsored by AN Wireless:  AN Wireless handles Rohn tower systems,
>Trylon Titan towers, coax, hardline and more. Also check out our self
>supporting towers up to 100 feet for under $1500!!  http://www.anwireless.com
>
>-----
>FAQ on WWW:               http://www.contesting.com/FAQ/towertalk
>Submissions:              towertalk@contesting.com
>Administrative requests:  towertalk-REQUEST@contesting.com
>Problems:                 owner-towertalk@contesting.com


List Sponsored by AN Wireless:  AN Wireless handles Rohn tower systems,
Trylon Titan towers, coax, hardline and more. Also check out our self
supporting towers up to 100 feet for under $1500!!  http://www.anwireless.com

-----
FAQ on WWW:               http://www.contesting.com/FAQ/towertalk
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com


<Prev in Thread] Current Thread [Next in Thread>