Towertalk
[Top] [All Lists]

[TowerTalk] Re: Remove enamel from CU wire

To: <towertalk@contesting.com>
Subject: [TowerTalk] Re: Remove enamel from CU wire
From: jskatz@sk.sympatico.ca (Sylvan Katz)
Date: Tue, 09 Oct 2001 09:57:22 -0600
Ooops.

Thanks for all of the responses. I made a small mistake. I should have made
it clear that I intend to leave the enamel on the wire except for a few
spots were I want to make a solder connection.

I guess I was just lazy -- a knife, a file and some sandpaper will do the
job but when I have to do tens of wires I start to look for a less labor
intensive solution :-) Anyway I have been told that enamel is no longer used
... apparently it has been replaced by a resin and there is nothing other
than elbow grease and fire that will remove it.

tnx for all of the wonderful suggestions.

.. sylvan

----------------
Sylvan Katz, VE5ZX
Saskatoon, SK


List Sponsored by AN Wireless:  AN Wireless handles Rohn tower systems,
Trylon Titan towers, coax, hardline and more. Also check out our self
supporting towers up to 100 feet for under $1500!!  http://www.anwireless.com

-----
FAQ on WWW:               http://www.contesting.com/FAQ/towertalk
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com


<Prev in Thread] Current Thread [Next in Thread>