Towertalk
[Top] [All Lists]

[TowerTalk] Re: PL259 connectors

To: <towertalk@contesting.com>
Subject: [TowerTalk] Re: PL259 connectors
From: zl1aih@ihug.co.nz (zl1aih@ihug.co.nz)
Date: Tue, 23 Oct 2001 21:44:27 +1300
K7GCO's methods have worked fine for me, even with poor 
quality PL-259s - sometimes you have to use whatever's 
available.
To make the job easier, (I use a 60 watt iron, large chisel bit), 
quickly tin the braid before exposing the centre conductor.   
With the standard measurements, cut through the tinned braid 
and dielectric with a -new- tubing cutter, almost to the centre 
conductor.
If you buy even a cheap tubing cutter, and use it only for coax 
plug fitting, it will last a lifetime.         
Twist off the cut braid and dielectric- if the conductor is solid, 
either way is fine.
If it's stranded, twist with the lay of the strands.
This method allows the accurately faced cable end to seat 
against the inside of the plug - no whiskers of braid, and a 
guaranteed pre-tinned braid for the four holes.
K7GCO's caveat re foam applies - close -wind any loose 
wound braid with fine bare copper wire, tin as before and then 
use the tubing cutter.    If the foam bleeds through the wound 
braid, cut the coax and start again.   Practice makes perfect. 
Serious hams should not be using cable with loose wound 
braid, but sometimes you have to use what's available.
73, Ken ZL1AIH

List Sponsored by AN Wireless:  AN Wireless handles Rohn tower systems,
Trylon Titan towers, coax, hardline and more. Also check out our self
supporting towers up to 100 feet for under $1500!!  http://www.anwireless.com

-----
FAQ on WWW:               http://www.contesting.com/FAQ/towertalk
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com


<Prev in Thread] Current Thread [Next in Thread>
  • [TowerTalk] Re: PL259 connectors, zl1aih@ihug.co.nz <=