In a message dated 12/2/01 2:21:10 PM Eastern Standard Time, [email protected]
writes:
<< 1. Apply two wraps of premium electrical tape (Scotch 33+ or 88).
2. Apply a layer of vapor-wrap material. Vapor-wrap is simply a butyl
rubber
material that comes in rolls or sheets and does an excellent job of
isolating
the joint from the elements. (Okay - you can use CoaxSeal for this. DO NOT
put CoaxSeal directly on connectors!) >>
Hello Steve, could you tell do I need to wrap the connector first with tape
then with coax seal and why.
Thanks,
Danny T93M
List Sponsored by AN Wireless: AN Wireless handles Rohn tower systems,
Trylon Titan towers, coax, hardline and more. Also check out our self
supporting towers up to 100 feet for under $1500!! http://www.anwireless.com
-----
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Submissions: [email protected]
Administrative requests: [email protected]
Problems: [email protected]
|