Red wrote:
> An article about corrosion by Scott Roleson, KC7CJ, appears in the April
> 1993 QST. It includes a table of the galvanic series showing aluminum
> is more anodic than iron or mild steel, which would cause the aluminum
> to corrode instead of iron if galvanic corrosion is the problem. I have
> no information on the potential of the alloy from which Grade 5 or Grade
> 8 bolts are made or that of the 6063-T832 alloy from which the Universl
> Tower legs are made.
>
> The table of reduction potentials in the McGraw-Hill Encyclopedia of
> Science and Technology confirms that aluminum is more anodic than iron,
> but says nothing about alloys of steel or the many alloys of aluminum.
>
> 73 de WOØW
If you are using good galvanized bolts, then it is the galvanic reaction of
zinc and aluminum that is important, since those are the two metals that are
actually in contact with each other in the outside environment. You will
find those two metals very close to each other on the table of galvanic
reactions meaning there should be very little galvanic action (corrosion)
taking place between them.
Stan
w7ni@easystreet.com
________________________________________________________________________
Where do you get ICE bandpass filters & beverage matching boxes? The
same place that pays for the hosting of this list: The eHam Store.
Order online at http://store.eham.net.
-----------------------------------------------------------------------
-----
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
|