Dan,
Not sure, but I think it's .367" ..
7/16 = .4375 .. OD
wall thickness of .035 would give .367 for ID
wall thickness of .049 would give .339 for ID { these are standard
wall thickness of .065 would give .307 for ID
I think it's .035 thick ... don't have my 'manual' with me.
Don
N8DE
Dan Levin wrote:
>
> Can anyone tell me that inner diameter of the tubing that makes up the
> element tips of the Hy-Gain 105CA? I know that the outer diameter is .438",
> but I need the inner diameter. Thanks much!
>
> ***dan, K6IF
>
> ________________________________________________________________________
> Where do you get ICE bandpass filters & beverage matching boxes? The
> same place that pays for the hosting of this list: The eHam Store.
> Order online at http://store.eham.net.
> -----------------------------------------------------------------------
>
> -----
> FAQ on WWW: http://www.contesting.com/FAQ/towertalk
> Submissions: towertalk@contesting.com
> Administrative requests: towertalk-REQUEST@contesting.com
> Problems: owner-towertalk@contesting.com
________________________________________________________________________
Where do you get ICE bandpass filters & beverage matching boxes? The
same place that pays for the hosting of this list: The eHam Store.
Order online at http://store.eham.net.
-----------------------------------------------------------------------
-----
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
|