Towertalk
[Top] [All Lists]

[Towertalk] Hy-Gain Rotators

To: <towertalk@contesting.com>
Subject: [Towertalk] Hy-Gain Rotators
From: n2mg@eham.net (Mike Gilmer, N2MG)
Date: Tue, 05 Nov 2002 11:16:14 -0400
The sticky-brake (or something that acts like one) is such a well known 
problem that some electronic controllers actually bump the rotator in 
the opposite direction automatically (Rotor-EZ comes to mind).

However, since you claim to have never seen this before with your 
rotator, this could be a thrust-bearing/mast/rotator alignment 
problem.  Perhaps as you rotate, you pass through an azimuth "window" 
with considerable binding.  If you stop in that window, you might find 
it difficult to get it started again.  But if you "blow through it" and 
come out the other side, you are OK.  Perhaps that window is "...50 
degrees or so from either of the limits..." so you cannot "blow through 
it".

Mike N2MG

AA5BH wrote:
Whenever I turn the rotator within 50 degrees or so from either of the 
limits, the rotator will most likely not turn again for a few hours.  Overnight 
works best. My T2X is on an 80 Trylon freestanding tower 
connected to the control box with 225 feet of brand new, name brand, 
heavy duty cable.  We've bench tested the control box and are confident 
the problem is not in the box.  All cable ends have been triple checked 
for tightness, location, etc.   On the next weekend with good weather, 
the last thing we're going to do is exchange my T2X for a friend's 
spare to see if we can duplicate the problem with a different rotator.  
A friend who has a T2X tells me they always have to be "bumped", that 
is, release the brake then push the CW or the CCW lever on then off.  
Sometimes this helps.  It also helps to rotate the rotator a little in 
the opposite direction you really want to go, then brake and turn the 
opposite way, the way you really want to go.  Never again will I run my 
T2X anywhere near the limits.  I've owned this rotator since new and 
have never experienced this problem until this installation about one 
month ago.  Openings to VK or ZL or the South Pacific are no longer fun 
as they are about 230 degrees from my QTH.  Very close to the limit, 
and I am sure, once turned there, that's where the antenna is pointed 
for a few hours.

<Prev in Thread] Current Thread [Next in Thread>