Towertalk
[Top] [All Lists]

[Towertalk] Mounting multiple antennas on mast

To: <towertalk@contesting.com>
Subject: [Towertalk] Mounting multiple antennas on mast
From: k4oj@tampabay.rr.com (k4oj)
Date: Sun, 17 Nov 2002 19:51:19 -0500
I have seen that done a lot...the other method (assuming your mast is 
rated for it) is easier but takes more retention... climbing steps on 
the mast.

K4OJ



Wes Cosand wrote:

> I'm have not seen much discussion of an topic that worries me.  I'm 
> not certain I am using "best practices".
>
> How do most folks go about mounting multiple antennas on a mast?    
> Here is my technique.  Is there a better procedure?
>
> I erect the tower with a rotor shelf and two thrust bearing shelves 
> with the mast inserted through the three shelves without the rotor.  
> Then  I mount and tune the top beam on the mast.  Then I use a small 
> "come along" hoist between the top shelf and a U-bolt low on the mast 
> to raise the mast before clamping the thrust bearings in preparation 
> to mount the second beam.  The two thrust bearings keep the mast from 
> getting away from me while I mount the rotor.
>
> Is this the way everyone does it?
>
> Wes WZ7I
> _____________________
> Wes Cosand, PhD
> 6299 Durham Rd; Rt 413
> PO Box 349
> Pipersville, PA 18947-0349
> Email: wz7i@arrl.net
> Phone: 215-766-3842
> FAX:   215-766-3843
> _______________________________________________
> AN Wireless Self Supporting Towers at discounted prices, See 
> http://www.mscomputer.com
> Wireless Weather Stations now $349.95. Call Toll Free, 888-333-9041 
> for additional information.
> _______________________________________________
> Towertalk mailing list
> Towertalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>



<Prev in Thread] Current Thread [Next in Thread>