In addition, don't overlook a tool called the "Solder
Sucker" - at least that's the name of one the one I have.
It's basically a small squeeze bulb type device with a small
plastic tip. You heat the joint until the solder melts,
collapse the bulb, apply the tip to the joint and quickly
release the bulb. It "sucks" the solder out of the joint.
It's been helpful on several occasions when due to the
through plating of a circuit board "Solder Wick" couldn't
quite get all of the solder. It is also available at
numerous electronics suppliers.
Just another option...
73
Patrick
W7TMT
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of W3YY
Sent: Wednesday, October 20, 2004 16:33 PM
To: TowerTalk List
Subject: Re: [TowerTalk] replacing relay
Les -
Are you familiar with solder wick? This is used to suck up
any excess solder from a solder point. If you have multiple
points that need to be unsoldered to release a component,
this is the way to go. Solder wick is available from
electronic supply stores and Radio Shack.
73, Bob - W3YY
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|