I hoisted a fully charged Milwaukee 1/2 drive cordless drill up the tower
and used a new titanium bit. I also took up a spare battery but did not
have to use it.
73, Keith NM5G
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Terry Gerdes
Sent: Wednesday, April 19, 2006 12:26 PM
To: [email protected]
Subject: [TowerTalk] Pinning a high carbon steel mast
All,
I need to pin one of the Texas Towers high carbon steel masts in the air.
I have pined several steel masts but all on the ground with a drill press.
Any advise?
Thanks,
Terry - AB5K
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
|