I use standard 1/2" hardline around the rotators for more then 20 years
without any problem or cable break.
The cables are formed into a one layer spring like that in a mechanical
clock.
My rotators turn 540°
73
Peter
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Hector Garcia XE2K
Sent: Sonntag, 30. April 2006 21:35
To: [email protected]; [email protected]
Subject: Re: [TowerTalk] superflex for rotor loop?
i will not use that Hardline for rotor loop, is just
superflex because can be reduced the diameter smaller
than the conventional hardline, in continous bending
will break sooner or more than sooner.
use the 9913f or LMR
--- [email protected] wrote:
> Is Andrew 1/2 inch superflex continuously flexible
> enough to be suitable for
> use as a rotor loop?
>
> Thanks,
> Tom K4RV
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> [email protected]
>
http://lists.contesting.com/mailman/listinfo/towertalk
>
Hector Garcia XE2K / XF1K
Mexicali B.C DM22fp
http://www.dxxe.org
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
|