Hello all,
Thanks to everyone that has replied to my previous posts and answered some
questions for me. In working on getting the tower up, my next question is this:
I want to top out my R25 with the BPL25G top thrust bearing plate. This plate
has three holes for guy wire attachment. If I guy to these holes (which I
would want to do), the tower will be guyed 3.5' higher than shown on the Rohn
drawings. (41.5' tower guyed at 41.5' instead of 38'). Do I need to adjust the
"ground length" of the guy so that the same angle is achieved as would be with
a 40' tower guyed at 38'? Or does this angle really matter so long as the
tower is guyed at 80% of it's height as called for by Rohn? Thank you very
much.
Happy DXing!
Jon, N7XW
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|