Towertalk
[Top] [All Lists]

Re: [TowerTalk] US Tower MA-40

To: Mike K6BR <noddie@comcast.net>
Subject: Re: [TowerTalk] US Tower MA-40
From: Dino Darling <dino@k6rix.com>
Date: Thu, 25 May 2006 18:22:08 -0700
List-post: <mailto:towertalk@contesting.com>
Straight out from the pulley at the top of the tilt-over bar.  In other
words, the cable should go UP and then out at a 90 degree angle. 
Remember, the cable goes out to the tower and BACK to the tilt over
bar!


Dino  -  K6RIX
dino@k6rix.com


> -------- Original Message --------
> Subject: [TowerTalk] US Tower MA-40
> From: "Mike K6BR" <noddie@comcast.net>
> Date: Thu, May 25, 2006 4:17 pm
> To: <towertalk@contesting.com>
> 
> Hi all,
> 
>  
> 
> I have an older MA-40 US Tower with an MARB Freestanding tilt over rotor
> base.
> 
>  
> 
> Could someone tell me how far up the tower the tilt-over clamp for the cable
> should be positioned please?  I have looked on US tower?s site, and of
> course no information.
> 
>  
> 
> Thank you,
> 
>  
> 
> Mike K6BR
> 
> 
>   _____  
> 
> I am using the free version of SPAMfighter for private users.
> It has removed 47 spam emails to date.
> Paying users do not have this message in their emails.
> Try SPAMfighter <http://www.spamfighter.com/go.asp?t=249>  for free now!
> 
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>