Well I have a Steppir without boom strut and guy wires in the way on
the bottom. Maybe I'll have to make a coax and steppir cable
"strut". Maybe a horizontal support a couple of feet above the
antenna that holds the coax out away from the tower and rotor parts?
-Dave NN5K
David Robbins K1TTT wrote:
>There are 2 ways I have used. The most common is to run the line up the
>tower to the height of the boom brace struts, then loop it down and back up
>to the strut and then down the strut to the beam. This of course assumes
>you have a beam that needs the strut. Though in one case I couldn't do the
>following method because of guy wires so I had to put a single strut up just
>for the rotor loop.
>
>The other way is to go down below the ring and leave a loop hang down and
>bring it up to the outside of the boom cradle. This won't work if the ring
>is too close above a guy wire as most of mine are.
>
>
>David Robbins K1TTT
>e-mail: mailto:k1ttt@arrl.net
>web: http://www.k1ttt.net
>AR-Cluster node: 145.69MHz or telnet://dxc.k1ttt.net
>
>
>
>
>>-----Original Message-----
>>From: towertalk-bounces@contesting.com [mailto:towertalk-
>>bounces@contesting.com] On Behalf Of Dave Fuller
>>Sent: Monday, September 11, 2006 20:52
>>To: TTalk
>>Subject: [TowerTalk] Tic ring feeline
>>
>>How about some proven methods of running the feedline to a beam on a Tic
>>ring?
>>
>>-Dave NN5K
>>_______________________________________________
>>
>>
>>
>>_______________________________________________
>>TowerTalk mailing list
>>TowerTalk@contesting.com
>>http://lists.contesting.com/mailman/listinfo/towertalk
>>
>>
>
>
>
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|