Mounted my 17 meter stub on the same leg as the 40 meter...no
problem, except tuning was tricky, has to move the stud a little
closer to the tower to get the standing wave where I wanted it...
Look at the pix of the tower and look at the left side and you'll see
the assembly...17/40...
-Bill
http://www.kc4pe.com/amateurshack.htm
At 09:57 PM 11/7/2006, K9AJ wrote:
>Hello All,
>
>I'm replacing an old HyGain HyTower that was first installed over 25
>years ago.
>
>The stock HyTower comes w/ decoupling stubs for 10m, 15m, and
>40m. The instructions say to install each decoupling stub on a
>different tower leg. However, I also bought the MK-17 17m decoupling
>stub kit for 17m. The instructions for this add-on are rudimentary,
>to say the least, and I'm wondering if installing the 17m decoupling
>stub means I must elect to not install one of the other stubs
>(ie: 10m, 15m & 40m).
>
>Seems to me I can't have two stubs on one tower leg-or can I?
>
>If someone else is also replacing an old HyTower, e-mail me
>privately, as HyGain/MFJ has changed the tower base and the new base
>does not match up w/ the concrete base tube alignment in the old HyTowers.
>
>73's.....Mike/K9AJ
>
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|