Hi Roger,
Here is a single purpose crimper for LMR600 connectors that is a compound
leverage straight closing die type:
http://sharperconcepts.zoovy.com/category/tools.crimptools
It ain't cheap but should last a while on the type of duty you'll be using it
on. Not sure if jaws are interchangeable for other sizes of connectors.
Just thought I'd put my two cents in !
Nick WB7PEK
Somewhere in now windy and wet western Washington
122 mph gust on 3000 foot Mt. Hebo 60 miles SW of here!
Message: 7
Date: Thu, 16 Nov 2006 03:42:46 -0500
From: "K8RI on TowerTalk" <K8RI-on-TowerTalk@tm.net>
Subject: Re: [TowerTalk] Coax Crimp tools/Dies/reasonable cost
To: "Pat Barthelow" <aa6eg@hotmail.com>, <towertalk@contesting.com>
Message-ID: <003701c7095b$30d5a450$6500a8c0@SecondOne>
Content-Type: text/plain; format=flowed; charset="iso-8859-1";
reply-type=original
I've been looking at this but so far haven't found the die set for LMR-600.
I have 1000 feet of LMR-600 on the way. (thanks to those who pointed out
the discount places for the *brand name* stuff) along with connectors. I
just need the crimping tool and dies.
>
____________________________________________________________________________________
Do you Yahoo!?
Everyone is raving about the all-new Yahoo! Mail beta.
http://new.mail.yahoo.com
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|