Towertalk
[Top] [All Lists]

Re: [TowerTalk] Sheet copper ground

To: "Bill Turner" <dezrat@copper.net>, <towertalk@contesting.com>
Subject: Re: [TowerTalk] Sheet copper ground
From: "Barrie Smith" <barrie@centric.net>
Date: Wed, 27 Jun 2007 11:41:02 -0600
List-post: <mailto:towertalk@contesting.com>
>
> >I'd like to improve my grounding system, which, due to clay and rocks, is
mostly nonexistant.
>
> ------------ REPLY FOLLOWS ------------
>
> What kind of ground are you wanting to improve?
>
> 1. AC mains safety ground?       Yes
> 2. Lightning protection ground?    Yes
> 3. RF ground for transmitting and receiving?    Yes
>
> If #3, what frequencies and what kind of antenna?

I'm QRV 6M, 432 and 1296 EME.  However, in the winter, I chat a bit on 160
and 75M.  I plan to shunt-feed a 85' tower, with four 7 el yagis on a 30' x
30' h-frame, for 75  and 160M, soon.

I will lay out radials for that shunt-fed tower.

Since my ground rods are non-existant, this sheet copper ground system would
be placed at the base of the tower and another just outside the shack.

My question is:  Would several square feet of copper, buried a foot deep, be
an effective ground system?

73, Barrie, W7ALW
>
> Bill W6WRT
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>