Towertalk
[Top] [All Lists]

Re: [TowerTalk] B&W Center Insulator for dipoles

To: <Al_N6TA@comcast.net>, "TowerTalk" <TowerTalk@contesting.com>
Subject: Re: [TowerTalk] B&W Center Insulator for dipoles
From: "Clint Talmadge" <unclebudd@bellsouth.net>
Date: Sat, 7 Jul 2007 20:08:07 -0500
List-post: <mailto:towertalk@contesting.com>
You are  missing a rubber "doughnut" that slips over the RG8 or 213 and 
squeezes it tightly enough to support the weight of the cable. I still have a 
brand new in the box B&W dipole center kit as you described it.

Clint - W5CPT

  ----- Original Message ----- 
  From: Al_N6TA@comcast.net 
  To: TowerTalk 
  Sent: Saturday, July 07, 2007 7:54 PM
  Subject: [TowerTalk] B&W Center Insulator for dipoles


  One of my junk drawers just coughed up a B&W cast aluminum center insulator 
for dipoles.  It is a two piece clamshell design that is really heavy duty with 
eye bolts, ceramic insulators, gaskets and seems to want to clamp to the coax 
feedline.
  My question to the old timers out there is why is hole for the coax 9/16 " 
diameter, much too large for RG-8 type coax?  Am I missing a part that is a 
gasket of some kind that would make the RG-8 fit?  

  If this B&W unit is used correctly, I seems like it could take a LOT of 
tension and weight of coax hanging a long way down.  I plan to raise my 80 M 
dipole to heights it has never seen before!

  Tnx
  Al
  N6TA
  _______________________________________________



  _______________________________________________
  TowerTalk mailing list
  TowerTalk@contesting.com
  http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>