>From several recommendations I've read, conductivity through the rotor is
not great thanks to the bearings. And the rotor can suffer damage due to
lightning. The purpose is to improve grounding of the mast and antenna. As
the whole thing is going to rotate, I assume you need something very
flexible.
73,
Mark N3GNW
----- Original Message -----
From: <K7LXC@aol.com>
To: <towertalk@contesting.com>; <Mark.Kempisty@L-3com.com>
Sent: Friday, August 03, 2007 3:59 PM
Subject: Re: [TowerTalk] What's best way to bypass rotor with ground strap?
>
> In a message dated 8/1/2007 6:18:21 P.M. Pacific Daylight Time,
> towertalk-request@contesting.com writes:
>
>> What is the best way/location to bypass the rotor with a ground strap?
> At the coax loop, at the rotor, elsewhere? What's the best way to do
> it? Coil the braid around the mast or just let it hang out in a short
> loop?
>
> What is the function of the ground strap bypass? You've got electrical
> continuity thru the rotator already so I'm not sure why you need an
> additional
> strap.
>
> BTW braid is not recommended for any grounding application. Eventually
> each strand will oxidize and be non-conductive to the other strands.
> There'll
> be continuity end-to-end but not strand-to-strand so you'll wind up with
> much
> more resistance than you started with rendering your ground strap mostly
> useless.
>
> Cheers,
> Steve K7LXC
> TOWER TECH -
> Professional tower services for hams
> Cell: 206-890-4188
>
>
>
>
>
>
>
>
>
> ************************************** Get a sneak peek of the all-new AOL
> at
> http://discover.aol.com/memed/aolcom30tour
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|