Towertalk
[Top] [All Lists]

Re: [TowerTalk] RG6

To: "Dan Zimmerman N3OX" <n3ox@n3ox.net>, <towertalk@contesting.com>
Subject: Re: [TowerTalk] RG6
From: "jeremy-ca" <km1h@jeremy.mv.com>
Date: Tue, 11 Sep 2007 17:58:43 -0400
List-post: <mailto:towertalk@contesting.com>
Didnt do an autopsy, I could see the zap in the dark. Insulation broke down 
with the VSWR developed voltage. It was around 4:1 at 3.8 MHz. Luckily it 
was only 2' away from the connector so I just cut it back and put on a new 
connector.

Carl
KM1H


----- Original Message ----- 
From: "Dan Zimmerman N3OX" <n3ox@n3ox.net>
To: <towertalk@contesting.com>
Sent: Tuesday, September 11, 2007 5:40 PM
Subject: Re: [TowerTalk] RG6


>> Ive zapped ComScope quad shield on 75/80M with 1500W by trying to run a
>> sloper on both ends of the band.
>
> Jeremy,
>
> Got any more specific description than "zapped" or did you not do an 
> autopsy?
>
> Did it seem to be voltage breakdown or heat related?
>
> I guess it was SSB/CW duty cycle since you were at both ends of 75/80...
>
> I'd be interested 'cause CommScope QS or equivalent is the sort of
> stuff you can find easily in the home improvment stores...
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
> 

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>