I posted this a few days ago and since I didn't get a reply maybe I thought it
just didn't go thru so I'm throwing it out there again and appreciate any help
in looking for the answers I looking for
73
John
KO4XJ
I'm just starting to plan for next springs tower project..I'm taking two Rohn
25G towers down from a SK and one is 60' and the other is 50' and I'm wanting
to put 60 or 70 ' back up. I will probably go back up with my TA-33 with the 40
meter add on, a 17 meter mono bander and probably a 6 meter antenna plus
planning to hang a few wire antennas off of it
Now somewhere I read and I'm interested in a tilt over design using some 25G
next to the tower and it's used as a pulley point (gin pole) to aid in lowing
and raisng the 60+' tower
Can someone direct in the right direction for this design. I'm also researching
the elevated guy points also due to my restricted acre.
The falling derrick method is workable but I'd have to access my neighbors
property and I'd rather not use that method until last resort and getting a
crane is not a problem but I'd like the ability to lower and raise for changes
and maintenace without the rentals
Thanks in advance and 73
John
KO4XJ
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|