Towertalk
[Top] [All Lists]

Re: [TowerTalk] Installation Rohn 25G

To: <towertalk@contesting.com>
Subject: Re: [TowerTalk] Installation Rohn 25G
From: "AD5VJ Bob" <rtnmi@sbcglobal.net>
Date: Sun, 11 Nov 2007 16:20:39 -0600
List-post: <mailto:towertalk@contesting.com>
 I said 03 feet of gravel I meant to say 03" of gravel sorry abt the typo.

> -----Original Message-----
> From: towertalk-bounces@contesting.com 
> [mailto:towertalk-bounces@contesting.com] On Behalf Of AD5VJ Bob
> Sent: Sunday, November 11, 2007 4:13 PM
> To: towertalk@contesting.com
> Subject: [TowerTalk] Installation Rohn 25G
> 
> I am digging a hole to install my rohn 25g tower.
> 
> I have the cement and am trying to make sure after reading 
> the rohn documentation that I have interpreted all of this correctly.
> 
> I am going up 40 feet at this point (ONE EACH THREE ELE 
> TRIBANDER AND ROTOR) with plans to add to the tower later 
> with additional sections.
> 
> I will be using part of a section in the ground (4 feet I 
> think) and then attaching the rest I suppose by using a home 
> made gin pole.
> 
> The dimensions as I understand it for the hole should be:
> 2'X2'X4'
> 
> Before I go out there in this rocky soil and break my back 
> with my pick and shovel I would just like to know that the 
> dimensions and procedure are correct. :)
> 
> Then I lay 3' of gravel which I have, center the section in 
> the whole, try to devise someway to hold it still after 
> checking it with my level and plumb-bob and pour. 
> 
> No guy wires at this point in time. 20 meters here I come.
> 
> Is that about it??
> 
> TNX BOB AD5VJ
> 
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
> 

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>