I would be very wary of doing that, since the higher temperature
required for silver soldet would likely melt the foamed dielectric of
the cable. perhaps a F compression connector and an adapter like
<http://outlet.cableorganizer.com/NQP-CAD-1380.html?section=8&catname=
%0ARF+Coaxial+Connectors+%5D+Interseries+Adapters> would meet your
needs.
Bob, N7XY
On Nov 15, 2007, at 1:59 PM, John Hudson wrote:
> Somerwhere I read in the archieves and can not seem to locate it
> now, someone posted they made life easier soldering RG-6 (alumimum
> braid) to PL-259's using "silver solder" and listed a source for
> the solder. I've using quad shield...
>
> Could someone send me that reference again and/or any new
> experiences with this, off-list please.
>
> Thanks
>
> John
> KO4XJ
> jd_hudson@comcast.net
> .
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|