Towertalk
[Top] [All Lists]

Re: [TowerTalk] Antenna Interaction

To: towertalk@contesting.com, Lou Laderman <lladerman@earthlink.net>
Subject: Re: [TowerTalk] Antenna Interaction
From: Edward Sylvester <navydude1962@yahoo.com>
Reply-to: navydude1962@yahoo.com
Date: Thu, 7 Aug 2008 12:21:50 -0700 (PDT)
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Thanks, Lou...Very helpful!!
 
73,
Ed NI6S

--- On Thu, 8/7/08, Lou Laderman <lladerman@earthlink.net> wrote:

From: Lou Laderman <lladerman@earthlink.net>
Subject: Re: [TowerTalk] Antenna Interaction
To: navydude1962@yahoo.com, towertalk@contesting.com
Date: Thursday, August 7, 2008, 11:52 AM

I sent this link in reply to another similar question a couple of days ago.

http://www.ifwtech.co.uk/g3sek/stacking/stacking2.htm

Issue is not interference with the SteppIR from the VHF/UHF, but with the
VHF/UHF antennas by the SteppIR. Big advantage of the SteppIR is that it can
"disappear" when the elements are retracted.

Lou, W0FK 

-----Original Message-----
>From: Edward Sylvester <navydude1962@yahoo.com>
>Sent: Aug 7, 2008 1:39 PM
>To: towertalk@contesting.com
>Subject: [TowerTalk] Antenna Interaction
>
>Due to only having one tower and a 10' mast, I would like to see
whether it's feasible to put up the following: Steppir 3 element
(bottom) 12 element 2m horz beam with UHF 21 element horz beam at same level on
metal cross boom, sitting two feet above LPDA (50-1300 MHz) at the top,
vertically polarized. How much will the the V/UHF antenna setup two feet above
affect the Steppir pattern?? Thanks,Ed NI6SWhittier, CA
>
>
>      
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk




      
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>