Thanks to Richard and John for the info and photo of adapter and
yes, will check harbor freight !
That's looks like a great 1/2 inch Drill !
( ..and it's almost the same price as an electric hoist which would obviate
the need for the adapter scheme ! )
*http://tinyurl.com/b3nqe5
73, Dennis N6KI
*
On Mon, Mar 9, 2009 at 8:26 AM, Richard (Rick) Karlquist <
richard@karlquist.com> wrote:
>
>
> John Ammeter wrote:
>
> I bought a long socket that fit the nut. Then, I took a 4" 3/8 ratchet
>> extension and machined the female end off. Machined (actually had a friend
>> with a mill do it) three flats on that end. It worked fine but wobbled a
>> bit so I brazed the socket onto the extension. Be sure to keep the socket
>> straight on the extension when you braze it. I used a lathe; held the
>> extension with the lathe "head" and centered the socket with a pointed tool
>> in the endstock.
>>
>
> I can't believe you went to this trouble. You can buy square drive
> adapters that clamp in the drill chuck at Sears, Harbor Freight, etc.
>
>
>> The drill is a Milwaukee Hole Hawg drill set on the 300 RPM speed. I'd
>> already tried a 3/8" Makita and a 1/2" Milwaukee but they would heat up and
>> slow down after the tower raised up a few feet. The Hole Hawg has enormous
>> torque and does the job without any complaints at all...
>>
>> John KE7JA
>>
>
> Yes, this drill is the BOSS. The right angle configuration makes it much
> easier to hold. It has at least twice the power of a "Sears Best" etc.
>
> Rick N6RK
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|