Towertalk
[Top] [All Lists]

Re: [TowerTalk] plastic forms (!) for cage dipoles

To: towertalk@contesting.com
Subject: Re: [TowerTalk] plastic forms (!) for cage dipoles
From: Bill Tippett <btippett@alum.mit.edu>
Date: Fri, 17 Apr 2009 16:52:59 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
K0RC:

 >Also, the webpage didn't say what diameter they were either. 
Someone said 3" or
4". I was expecting something larger like 6" to 12". That's what you usually
see when fabricated from X braces.

         Yes it did:

http://www.rlham.com/cgi-bin/shop/modellookup.dbw?MODEL=JTCAGE

Outside  diameter  3  7/16"
Inside  diameter  2  7/16"
Holes  are  1/4"
Total  of  12  holes

         I've been looking for something like this to make the gamma
wire for my 160m vertical fatter.  These are perfect and cheap.  Looks
like you could even get by with 3 wires instead of 4 since the 12 holes
allow lots of options for configuration.

                                         73,  Bill  W4ZV




_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>