Steve Katz wrote:
> My first thought is "What kind of big vertical?"
>
> It appears you're using a standard bell housing rotator including the lower
> bracket/mast clamp. Is that correct? If so, that won't withstand much
> mast/vertical length above it; so all the guying in the world at the rotator
> or below it won't keep the rotator from breaking with a long vertical load
> above it.
>
>
I would hope the rotator is down int he tower where it belongs. If so
the top of the tower sleeve/thrust bearing takes the side load.
73
Roger (K8RI)
> -WB2WIK/6
>
> -----Original Message-----
> From: towertalk-bounces@contesting.com
> [mailto:towertalk-bounces@contesting.com]On Behalf Of Paul Young
> Sent: Friday, June 12, 2009 12:18 PM
> To: Towertalk
> Subject: [TowerTalk] guy line anchor ?
>
>
> Hi all,
>
> I have decided to add guy lines to my free standing tower.
> I have 2 good points to tie to but the 3rd I need to make.
> It will need to be some sort of ground anchor, and looking
> for pointers.
>
> My Tower is only 45ft wind up / tilt over in a concrete block
> and has been up for over a year fine with a 4 ely tri-bander,
> I would like to add a big vertical to the top so the reason for
> the guy lines.
>
> photos here: http://www.g0hwc.com/latest_projects.html
> at bottom of the page.
>
> Check out my website www.g0hwc.com *Echolink node MB7ICL-L "381900"*
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|