If you are looking at the ROUND connector, that is probably the quick
disconnect that is incorporated on the later rotors. You can get these from
Norm's Rotor Service as well.
-http://www.rotorservice.com
- Mike
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Larry Boekeloo
Sent: Saturday, October 31, 2009 3:56 PM
To: towertalk@contesting.com
Subject: [TowerTalk] Rotor Connector
Does anyone know what type of connector Hy-gain is using on their rotors
these days? I want to set up another rotor with the same type of connector
off of the pigtail.
Thanks.
Larry, KN8N
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
__________ Information from ESET NOD32 Antivirus, version of virus signature
database 4562 (20091101) __________
The message was checked by ESET NOD32 Antivirus.
http://www.eset.com
__________ Information from ESET NOD32 Antivirus, version of virus signature
database 4562 (20091101) __________
The message was checked by ESET NOD32 Antivirus.
http://www.eset.com
__________ Information from ESET NOD32 Antivirus, version of virus signature
database 4562 (20091101) __________
The message was checked by ESET NOD32 Antivirus.
http://www.eset.com
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|