Yes, a screwdriver works great. After mine broke, I never even considered
getting a replacement.
73,
Henry - K4TMC
-----Original Message-----
From: Dick Green WC1M <wc1m73@gmail.com>
To: 'Mike' <k4gmh@arrl.net>; towertalk@contesting.com
Sent: Sat, Jul 3, 2010 12:15 pm
Subject: Re: [TowerTalk] AB577 Clamp Wrench
Try Ontario Surplus: http://www.ontariosurplus.com
The wrench is part of the launcher assembly, so it doesn't show up on the
parts list. But Ontario might have them.
As I recall, a screwdriver works, too.
73. Dick WC1M
-----Original Message-----
From: Mike [mailto:k4gmh@arrl.net]
Sent: Friday, July 02, 2010 11:00 PM
To: towertalk@contesting.com
Subject: [TowerTalk] AB577 Clamp Wrench
Need to replace the wrench used to secure and remove the clamps on an
AB577. One of the wrench's prongs for engaging the clamp broke off during
Field Day installation of the tower. Any ideas where to obtain another
wrench or repair the broken one?
--
73,
Mike, K4GMH
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|