I have an older LM354 per nameplate and the bottom 4 hole mounting
flanges measure 20" outside to outside. The heavier duty towers step up
the section sizes.
Grant
KZ1W
>
> ----- Original Message -----
> From: "Mickey Baker" <[email protected]>
> To: [email protected]
> Sent: Sunday, August 1, 2010 8:55:58 PM
> Subject: [TowerTalk] Differentiating Tri-Ex Towers
>
> How would one tell if a tower were a LM-354, LM-354HD or an HM-354?
>
> Should there be a data plate or descriptive weld?
>
> Thanks and 73,
>
> Mickey, N4MB
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
|