I agree with Gary on this. Some time ago, I had my coax cables installed on the
inside of the tower. This is fine until you have to replace one of them. I
found it a huge PITA to remove the run that needed replacing. Mine are now ALL
on the outside!
73, Stew K3ND
--- On Mon, 8/16/10, Gary E. Jones <[email protected]> wrote:
> From: Gary E. Jones <[email protected]>
> Subject: [TowerTalk] FW: question on where to run coax
> To: [email protected]
> Date: Monday, August 16, 2010, 8:31 AM
> Unless you have massive numbers of
> coax run, (I routinely have had about 4
> runs per tower), they will fit very nicely up against the
> leg on the
> outside, There essentially is a notch where the diagonal
> braces weld to the
> steel tube legs (on Rohn Towers), and four runs of coax fit
> in that notch
> very nicely. I take the runs to the leg. I have never had
> any problems with
> crimping or crushing any coax/rotor runs and in fact, the
> bunched coax that
> is taped to the leg makes that leg slightly thicker in
> diameter which make
> it even easier to hold the tower legs with that hand when
> you are climbing.
> Pulling coax up through the center is a massive pain in the
> butt, IMHO
>
> 73
>
>
> Gary W5FI
>
>
>
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
|