Towertalk
[Top] [All Lists]

[TowerTalk] LM-354HD Sections Racking

To: <towertalk@contesting.com>
Subject: [TowerTalk] LM-354HD Sections Racking
From: "Michael Hofe, AI3H" <AI3H@thehofefamily.com>
Reply-to: "Michael Hofe, AI3H" <AI3H@thehofefamily.com>
Date: Tue, 7 Sep 2010 19:59:11 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
I was wondering if anyone has had the problem where the middle section of their 
LM-354HD racks inside the base section when the tower is extended?  What I mean 
is that the center section of tower will twist slightly and the top and bottom 
rollers (top and bottom of the middle section) will slip past the leg of the 
bottom section preventing the tower from being lowered unless you go up and pry 
the section / rollers back on the bottom section legs.  If so, has anyone 
devised a method of preventing the middle section from slipping off the bottom 
section leg?  I was thinking of fabricating some type of stainless steel shim 
that would be fastened to the bottom section leg that when the tower is full 
extended, the shims would be positioned between the rollers and the bottom 
section leg.  Any thoughts would be appreciated.

Mike, AI3H
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>