On 12/3/2010 4:58 PM, n8de@thepoint.net wrote:
> Instead of bringing the ladderline directly down the side of the
> tower, 'twist' it as you do, thereby changing the distributed
> capacitance of the two wires to the tower and 'equalizing' any
> capacitive problems.
> 3 or 4 turns should suffice for 50'.
>
> One foot sounds good to me, too.
I'd probably use about 1 turn per yard/meter as it's good for common
mode rejection and the extra turns wouldn't hurt (within reason)
I have no technical basis for choosing the number of turns/twists other
than it being convenient and a tiny fraction of a wavelength at the
frequencies they are likely to be used or encounter.
73
Roger (K8RI)
>
> 73
> Don
> N8DE
>
>
> Quoting W1JCW<W1JCW@hotmail.com>:
>
>> I slope mine at a 45 to a 4:1 balum, coax into the shack.
>>
>> I would think at least 1'.
>>
>> 73-
>> W1JCW
>> John
>>
>> --------------------------------------------------
>> From: "Sam Andrews"<sandrews@aristotle.net>
>> Sent: Friday, December 03, 2010 3:06 PM
>> To:<TowerTalk@contesting.com>
>> Subject: [TowerTalk] Ladder Line Spacing from a Steel Tower
>>
>>> I am going to rework my inverted vee supported near the top of the 50'
>>> tower with polyethylene insulated ladder line (300 or 450 ohm, from DX
>>> Engineering, or similar). How far off the tower leg or face should it
>>> held?
>>>
>>> 73, Sam AE5L
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|