Towertalk
[Top] [All Lists]

Re: [TowerTalk] PL259 to CATV Hardline

To: "TOWERTALK@contesting. com" <TOWERTALK@contesting.com>
Subject: Re: [TowerTalk] PL259 to CATV Hardline
From: Don Moman VE6JY <ve6jy.1@gmail.com>
Date: Sun, 5 Dec 2010 19:45:41 +0000
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
It might be worthwhile to point out that this applies to 75 ohm hardline
only, as the center conductor of the 50 ohm stuff is larger.  On the 1/2" 50
ohm hardline I have, the center conductor will go into the barrel, but you
have to force it.... which ensures a tight joint.  I use a 1/2 compression
to 3/8 FIP thread fitting which lets the barrel thread directly in - no it's
not the "right" thread, but close enough that it works fine and has good
conductivity without soldering.  I've done hundreds that way here.  I also
concur with the suggestion of a little dab of NOALOX under the compression
fitting.

73 Don
VE6JY

On Sun, Dec 5, 2010 at 7:03 PM, K8RI on TowerTalk
<k8ri-on-towertalk@tm.net>wrote:

> I've added a couple of photos of the 1/2" Hardline to PL259 adapter to
> http://www.rogerhalstead.com/ham_files/conn.htm
> I'ts very simple and works well although, if used for UHF I'd want to
> bore out the center and run the jacket all the way to the PL259
>
> 73
>
> Roger (K8RI)
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>