Thanks to all the respondents so far. It seems I may need to disassemble
the phasing section a third time(!) to be absolutely certain that all the
tubes have matching ends into the joining section. If you had asked me, I
would have sworn that I had done so at the first, but who knows? The 1st hole
of each tube IS =distant from the exposed end at each end, and yet I have
this 5/16" length difference. Were this not a phasing harness I would pass it
off, but...
K0MB
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|