Towertalk
[Top] [All Lists]

Re: [TowerTalk] pull lubricant -- follow-up (installing Heliax connector

To: "'Steve Maki'" <lists@oakcom.org>, "towertalk" <towertalk@contesting.com>
Subject: Re: [TowerTalk] pull lubricant -- follow-up (installing Heliax connector
From: "Dick Green WC1M" <wc1m73@gmail.com>
Date: Thu, 28 Jul 2011 15:13:09 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Aha. I clicked on "prep tools" and it wasn't listed. But when I searched on
the part number it was there.

As I said, my current need is minimal, so I'll put off getting one for now
-- unless that $50 minimum order size is real.

73, Dick WC1M

-----Original Message-----
From: Steve Maki [mailto:lists@oakcom.org] 
Sent: Wednesday, July 27, 2011 6:41 PM
To: towertalk
Subject: Re: [TowerTalk] pull lubricant -- follow-up (installing Heliax
connector

On 7/27/2011 3:49 PM, Dick Green WC1M wrote:

> Thanks. I went back and read the registration categories more carefully.
> They include "individual". So I setup and account and ordered an LDF4-50
> prep tool. It was about $19, quite a bit cheaper than TheRFC. They don't
> have a prep tool for LDF5-50, but in the past I've found that it's not all
> that hard to manually prep.

Actually they do, the Andrew MCPT-78.

We find it to work very well, and prefer it over both the drill mounted 
prep tools AND a hacksaw. On 1-1/4" and 1-5/8" though you can't beat the 
drill mounted prep tools, but they run a couple hundred bucks.

-Steve K8LX


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>