| To: | <TowerTalk@contesting.com> |
|---|---|
| Subject: | [TowerTalk] guy wire tension |
| From: | "Gregg Seidl" <k9kl@centurytel.net> |
| Date: | Thu, 13 Oct 2011 11:33:01 -0500 |
| List-post: | <towertalk@contesting.com">mailto:towertalk@contesting.com> |
I know this has been hashed over before but I can't rememeber. I think 10% of breaking load is what is recomended. So for 3/16th cable about 400 pounds and for 1/4 about 600 pounds. Is this correct? I have a Loos tensioner and I am doing fall check-up on my towers. Thanks Gregg K9KL _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TowerTalk] K0XG Orbital Rotor on US Tower HDX589, Andre VanWyk |
|---|---|
| Next by Date: | Re: [TowerTalk] Best Grease for Rotor bearings ?, Bill Aycock |
| Previous by Thread: | [TowerTalk] Solid Copper, Warrenwolff |
| Next by Thread: | [TowerTalk] Grease for Rotor bearings, Roger Kissel |
| Indexes: | [Date] [Thread] [Top] [All Lists] |