| To: | <towertalk@contesting.com> |
|---|---|
| Subject: | Re: [TowerTalk] Tool to tighten PL-259 connectors |
| From: | "Kenneth Goodwin" <krgoodwin@comcast.net> |
| Date: | Wed, 19 Oct 2011 14:50:25 -0500 |
| List-post: | <towertalk@contesting.com">mailto:towertalk@contesting.com> |
In line with W5IFP's suggestions, a spark plug boot puller that is normally rubber/plastic tipped would be a suggestion. Not sure how much torque you could develop, but it would be a cheap and quite workable solution. Ken K5RG _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TowerTalk] Tool to tighten PL-259 connectors, Jim Hargrave |
|---|---|
| Next by Date: | [TowerTalk] TowerTalk] 75 ohm cable...show me cable brand, Wilson Lamb |
| Previous by Thread: | Re: [TowerTalk] Tool to tighten PL-259 connectors, Mark Robinson |
| Next by Thread: | [TowerTalk] TowerTalk] 75 ohm cable...show me cable brand, Wilson Lamb |
| Indexes: | [Date] [Thread] [Top] [All Lists] |